Feature

●This product is made to be installed with 43mm (known as 1 1/2 inch solvent weld) pipe or fittings. If your pipe or existing fittings measure 40mm, or has PP printed on it, then this product is not compatible and you will require 40mm pushfit or compression fittings
●This listing is for a Pack of 1
●Solvent weld waste pipe conversion elbow designed to join 2 waste pipes in a 90 degree configeration, one side to accept a pipe and one side to fit into another fitting
●Solvent weld fittings are secured using solvent weld cement for a permanent and strong installation
●Being a conversion bend the female end will accept 40mm (43mm) solvent weld pipe and the male end is designed to go into a 40mm (43mm) solvent weld fitting


Description

Product description

40mm (Actual Pipe Size is 43mm) White Solvent Waste Pipe 135 Degree Conversion Bend. Important Note: Solvent Weld Waste Pipe fitting sizes are often stated in metric standard measurements, however the actual pipe size is measured in imperial. The three options are as follows - 32mm Solvent Weld Pipe actually measure 1 1/4 inchs or 36mm, 40mm Solvent Weld Pipe actually measure 1 1/2 inchs or 43mm, 50mm Solvent Weld pipe actually measure 2 inchs or 56mm. In addition if the term "ABS" is printed on the pipe this identifies the pipe as solvent weld waste pipe.

Legal Disclaimer

PLEASE NOTE: we only use reputable couriers, during peak times (particularly during the Covid-19 pandemic) delivery times may be delayed. We only sell products we physically have in stock and will dispatch your order on time, however please bear in mind that even with our best endevours delays may occur which we may not be able to control. ESDA Ltd cannot be held responsible for delays in delivery or any other consiquential loss. Full terms and conditions of purchase are available on request, your statutory rights are not affected.