Specifications:
Voltage: AC100V~250V
Power: <1.0W
Output: Active output, output voltage equals to input voltage.
Max. Output Current: <10A
Input: Passive switch input, green led lights up after turn on, red led lights up after stopMounting Hole Diameter: 3.2mm / 0.12"
Instruction:
Time can be set when the board is powered on or powered off.
1, Set Run Time:
Adjust the RUN TIME potentiometer clockwise to increase, counterclockwise to decrease.
The red switch below can set time range(left, 0-100 or 0-1000)
and unit(right, Sec. or Min.)
2. Set Stop Time:
Adjust the STOP TIME potentiometer clockwise to increase, counterclockwise to decrease.
The red switch below can set time range(left, 0-100 or 0-1000)
and unit(right, Sec. or Min.)
3. Start Button(Not included):
Connect a momentary push-button switch and press it, then green LED lights up indicating it is working. The board would automatically run according to the setting run time and stop time, infinite cycle.Press the start button again, then red LED lights up indicating it stops.
4. Time Setting Example:
Requirement: Run for 20 seconds, stop for 30 minutes, infinite cycle.
Settings:
(1)Set run time range to 0-100;
(2)Set run time unit to Sec.;