[1 Single]
[3 Pack]
[5 Pack]
A low profile ringless 810 Drip Tip intended for RDAs and top caps that have a 1/2 inch connector fitted with internal O-rings. This mouthpiece is made from polyetherimide (PEI) thermoplastic, often referred to Ultem, which is widely used in vaping because of its very high heat tolerance and good chemical inertness. It has a shallow body with a round tip and a tapered wide bore for a fantastic, smooth draw with no loss of suction and amazing clouds. Recommended for lower resistance coils, up to typically 0.5 ohms and direct to lung (DTL) vapours. Each Drip Tip measures 9 mm total height including 810 fitting by 19 mm diameter. Bore diameter: 11 mm at tip tapering to 9.5 mm at a base (wide bore). For 810 fitting measures 12.5 mm diameter by 5 mm length ringless. Weight: 1 gram. Comes in a 3-pieces pack.
PEI Thermoplastic