Feature
●【Quick fix】: Windscreen repair kit can quickly and effectively minimize the appearance of chips and cracks in your Windscreen within 20 minutes without special tools. Save your time and money to prevent damage from spreading. Restores Windscreen to near new condition. Keep a long term maintenance effect
●【Upgrade Design】: The new second-generation design is rugged. It has a stronger repair device and 4 thicker rubber feet allow you to secure the device better to the glass, resin can evenly spread over the glass. Finally, give you amazing repair results
●【Advanced Resin Formula】: The Windscreen repair kit contains an upgraded deep permeability resin repair fluid, the shear strength can reach to 20PA, the repair resin can be fully penetrated into cracks and rop chips with pressure pushed by pressure driver
●【Easy to use】: Windscreen chip repair kit is easy to use. Firstly, Clean and dry the Windscreen glass surface. Secondly, squeeze the resin into the cracks and put on the cured film, then quickly dry and solidify under ultraviolet light 5-10 minutes. Finally, the residual resin was scraped off with a spatula
●【Widely Application】: This Windscreen repair kit repairs all types of laminated Windscreenes such as damage of bullseye, cracks, chips, stars shaped chips, spider webs. Crack not more than 12 inches/ 30 cm and round damage not more than one inch in diameter. If you are not satisfied in any way, please feel free to contact us
Description
|
|
|
|
|---|---|---|
|
1. Align the middle of the bracket with the damaged position |
2. Rotate the pressure cylinder onto the installed bracket |
3. Put drop of repair fluid into the pressure cylinder |
|
|
|
|
|---|---|---|
|
4. Rotate the pressure bar into the pressure cylinder and wait for about 15 minutes for the repair fluid to slowly enter the damaged area |
5. Observe if the repair fluid is slowly squeezed into the damaged area until the repair is satisfactory. |
6. Remove the fixing bracket and observe the repair fluid penetration effect |
|
|
|
|
|---|---|---|
|
7. Drop some repair solution into the damaged area and cover it firmly with curing film |
8. Move the vehicle to the sunlight to fully absorb the UV rays and make the repair fluid solidify. (Note: must be placed in the sun to absorb UV rays and produce a focal point reaction before curing) |
9. After curing, remove the curing film and gently scrape off the solidified repair fluid with a razor blade |
ATTENTION
- 1. Take care that there is no water in the broken area before repair (water in the broken area cannot be repaired)
- 2. Do not repair in the open air, as UV rays during the day will cause premature curing that cannot be repaired. Please work indoors, in underground garages or in sheltered repair locations.
- 3. The damaged area must be dry and clean and free from dirt
- 4. The repair solution must be placed in the sun after penetration to absorb UV rays and produce a focal reaction before curing
