[160X95mm Plate]
HzdaDeve Magnetic Steeel Plate for Mono 2 160X95MM Fexible Build Platform for Anycubic Photon Resin 3D Printer Accessories Replacement Specification: Material: PEI and steel plate. Size: 160 x 95 mm. Compatible 3D printer: for Anycubic Photon mono 2 Package includes: 1 x building plate. 1 x magnetic base. Note: 1. Clean your building plate with isopropyl alcohol and keep it dry so that the magnet can work normally. Clean the flexible steel plate with wet paper if necessary. If the room temperature in your city is below 10, the print model is difficult to stick to the base. Please heat the magnetic base for a while before installation. 2. Check the best position to place the magnetic base on your building plate in case it is moved. Please tear the 3M adhesive first for approx. 20 mm and then install completely step by step. You can press it back and forth to ensure there is no gap or bubble. 3. Wait 48-72 hours for it to work better. 4. Place the flexible steel plate on the magnetic base and make sure the handle is facing you. 5. You may need to adjust the z limit switch after installation. (Not all printers need to adjust). It should be about 2.5 mm higher. This means that the pressure height is approx. 2.5 mm. You can print a spacer or nut to fill the difference. 6. Align your building plate so that it can work and print. Customer service: If there are any questions, just contact us freely, a satisfactory solution will be provided within 24 hours